|
TRA: Thermal Radiation Analysis |
|
Thermal Radiation Analysis is designed to analyse complex or simple thermal radiation problems normally associated with fire engineering design including fire spread between buildings and egress via evacuation routes. It may also be used to verify configuration factors used within heat transfer calculations. Terms and conditions: Your usage of this software implies your acceptance to abide by the terms of this end user license agreement as follows.
1. GRANT OF LICENSE. SFES grants to you a non-exclusive, non-transferable license to install and use the software on your computer. This license is conditional, based on the following limitations: (i) You may not reverse engineer, decompile, disassemble, or otherwise attempt to modify the software. (ii) If you have not obtained a license, then you may not remove, suppress, hide, or cause your program to skip the license box. (iii) You may not use the trial copy for purposes other than evaluation of the software. 2. LIMITED WARRANTY. This software is provided on an "as is" basis without warranty of any kind, expressed or implied, including, but not limited to implied warranties of merchantability or fitness for a particular purpose. All other warranties are also expressly disclaimed. Users of the software assume sole responsibility under national and local law for determining the appropriateness of its use in any particular application; for any conclusions drawn from the results of its use; and for any actions taken or not taken as a result of analyses performed. 3. SUITABILITY. The persons or companies using this software are solely responsible for thoroughly testing it to make sure it works to their satisfaction before obtaining a license. Therefore, by obtaining a license, the licensee indicates that the program has met his/her expectations and runs to his/her satisfaction. 4. COPYRIGHT. This software is protected by UK Copyright Law. You do not have the right to reproduce, publish or adapt this program in any way. |
|
· Any number of hot or cool surfaces at prescribed temperatures can be assessed. · The surfaces may be located at any orientation or angle to one another. · The results provide both hot spot radiation and the average radiation incident across a surface. · Fire spread between any boundary condition or evacuation route can be assessed. · The graphics provided can be readily copied and added to fire engineering strategies for review. · A technical user manual is provided with a set of examples. A shortcut to this data is automatically installed on your desktop. To contact us: E-mail: support@fire-engineering-software.com Note: After 30 days you will be prompted to provide the license serial number TRA provides you. TRA will only be licensed on the PC which generated the serial number. Licenses are non-transferable.
|
|
Salisbury Fire Engineering Software - SFES |
|
Fire Engineering Software |
